500 ohm cutting head

Post: # 174Unread post **ffwolfcone** Thu Dec 22, 2005 1:45 am

Can anyone tell the best way to drive a 500 ohm cutting head? With out getting a 500 ohm amp? I am trying to drive a Olsen cutting head. Anyone know anything about this head? any info??????

Post: # 180Unread post **ameisevinyl** Sun Dec 25, 2005 4:01 pm

you will need to build a impedance correction network
which consists out of an capacitor and a resistor:

check this out:

http://www.epicenter.de/carhifi/tipsundtricks/impedanzkorrektur.htm

sorry this is german ..but the pix are alright...

you ll have to figure out the values yourself...

hope this helps
mart

hrper · Post: # 189Unread post **hrper** Mon Dec 26, 2005 10:37 pm

WHats up FFWOLFCONE?!

kill on yer new cuutter, throw up some photos here of that thing.