Hello to all forum members.
I have a question about lacqers MDC.
My plating bath we worked until now with Apollo lacqers or Transco.
We started to do some testing with lacqers MDC, but we encountered a problem.
After electroplating, when the separation of the stamper lacqer, lacqer layer detaches completely from the aluminum plate (see photo attached).
This plastic layer is to join the stamper and there is no porblème to separate it from the stamper.
The result of the stamper is good and the first vinyl tests are good.
We carry the same preparation procedure as the lacqer with Apollo / Transco lacqers.
We also use the same settings electroplating.
Someone knows if you have to change something in the way of preparing the lacqer settings or bath?
Thank you in advance for any help or advice as possible from you.
I am available for more information.
Good luck to all and sorry for my bad English!
Lacqers MDC and electroplating.
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
Lacqers MDC and electroplating.
You do not have the required permissions to view the files attached to this post.
Best regards.
David
Cutting & Galvanoforming
https://www.facebook.com/galvanoforming
https://www.youtube.com/channel/UCYoOS53WYfPDZnIIFdRFpaw
David
Cutting & Galvanoforming
https://www.facebook.com/galvanoforming
https://www.youtube.com/channel/UCYoOS53WYfPDZnIIFdRFpaw
- Aussie0zborn
- Posts: 1825
- Joined: Sat Mar 11, 2006 8:23 am
- Location: Australia
- Contact:
Re: Lacqers MDC and electroplating.
This can happen with any brand of lacquer when they are very fresh. Did you shave the entire edge off the lacquer disc?
Re: Lacqers MDC and electroplating.
Hello.
I have no information if lacqers are very fresh ...
I tried to shave outside all ways : full, partial and without shaving .
The result is always the same ....
Cordially.
I have no information if lacqers are very fresh ...
I tried to shave outside all ways : full, partial and without shaving .
The result is always the same ....
Cordially.
Best regards.
David
Cutting & Galvanoforming
https://www.facebook.com/galvanoforming
https://www.youtube.com/channel/UCYoOS53WYfPDZnIIFdRFpaw
David
Cutting & Galvanoforming
https://www.facebook.com/galvanoforming
https://www.youtube.com/channel/UCYoOS53WYfPDZnIIFdRFpaw