vinyl recorder with precision motor

[marcy108]

i set cutterhead as possible as parallel with earth.please take a look pic.
(i ask to souri about screw.but he still reply me...)

but problem still don't go away....
it' not complete parallel,but i think it can tolerance.how about?

last way is change turntable bearing to new one.

can anyone show other point?
i still need your help.
any help would be appreciated!

best regard,
marcy

[sat159p1]

imho, setting "pararell to earth" isn't a good thing. Unless you did the same with your working table, VR table, VR turntable, and VR haevy platter. Then it's OK. If you don't do it, keep it pararell to the platter.

[marcy108]

hi sat159p1,

thank you for reply.
sorry what mean working table?

anyway also cutterhead holder(sorry,i said "cutterhead" at last post,The correction is "cutterhead holder") is parallel to the platter.
(platter is set parallel to earth.)

what do you say?

i still need help.
any advice would be appreciated!

[marcy108]

i disassembled turntable bearing and clean them.then used oil.
but problem still remain...

i appreciate your continued support!

[Gus]

this is no good thing, i recommend to try with a new spindle.

IMG_8833.JPG

[marcy108]

Hi Gus,

Thank you for showing your opinion!
Now I'm waiting new bearing.
I'll post again when I receive it and use it.

Thank you your continued support!

[marcy108]

Hi everybody,
I use new turntable bearing.
Finally my Problem went away!
Groove is stable.I'm so happy!!!

Thank you very much who advice me!!
Marcy

[Gus]

Hi everybody,
I use new turntable bearing.
Finally my Problem went away!
Groove is stable.I'm so happy!!!

Thank you very much who advice me!!
Marcy

Be careful i think souri didn't calculate his (precision= i'm not sure) platter vs Technics spindle/bearing
That means in the near future maybe will you need again to install a new one Technics spindle/bearing.
It's better to speak with Mike http://www.mikenewaudio.com/bearing.php to find a permanent solution for your problem.

[SueDenim]

Hi Marcy,

I'm very happy that you finally managed to resolve your problem!
I consider this thread has vital information for all VR owners so maybe it should be archived for all to discover on a future search.

[marcy108]

Be careful i think souri didn't calculate his (precision= i'm not sure) platter vs Technics spindle/bearing
That means in the near future maybe will you need again to install a new one Technics spindle/bearing.
It's better to speak with Mike http://www.mikenewaudio.com/bearing.php to find a permanent solution for your problem.

thank you for your suggestion.i'll contact him in near future!

I'm very happy that you finally managed to resolve your problem!
I consider this thread has vital information for all VR owners so maybe it should be archived for all to discover on a future search.

thank you,SueDenim!
yes,i hope this thread is useful for other VR users.


in the end,thanks again.
i appreciate you all who help me!