DIY Lathe + CuttingHead - Sillon'R - Clem

Anything goes! Inventors! Artists! Cutting edge solutions to old problems. But also non-commercial usage of record cutting. Cost- effective, cost-ineffective, nutso, brilliant, terribly fabulous and sometimes fabulously terrible ideas.

Moderators: piaptk, tragwag, Steve E., Aussie0zborn

User avatar
jjwharris
Posts: 189
Joined: Fri Jun 02, 2017 5:18 am

Re: DIY Lathe + CuttingHead - Sillon'R - Clem

Post: # 49205Unread post jjwharris
Sat Feb 03, 2018 5:01 am

I'd give crc or lighterfluid a try - it should remove any trace of adheisive left from the protective layer.

I've just shifted to using those diamond record player styli - It doesnt look as nice as yours as I'm just gluing them straight on to tungsten welding rod but man! What a difference! Tracking is much better and the sound seems a lot clearer!

I've been skipping turtle wax and heat (broken lamp and ran out of turtle wax) but it seems to be going as well as it was before.
Record Lathe Embossing Supplies - http://www.supplies.johnnyelectric.co.nz/

User avatar
CedLathe
Posts: 4
Joined: Tue Feb 07, 2017 7:23 am

Re: DIY Lathe + CuttingHead - Sillon'R - Clem

Post: # 49227Unread post CedLathe
Sun Feb 04, 2018 12:27 pm

Salut Clem, j'espere que tu vas bien ! FELICITATION ! tes essais sont impressionnant ! continue comme ça ! la bise

Post Reply