suction system to hold the blank

Anything goes! Inventors! Artists! Cutting edge solutions to old problems. But also non-commercial usage of record cutting. Cost- effective, cost-ineffective, nutso, brilliant, terribly fabulous and sometimes fabulously terrible ideas.

Moderators: piaptk, tragwag, Steve E., Aussie0zborn

Post Reply
User avatar
juba bc
Posts: 66
Joined: Thu Nov 06, 2014 8:58 am
Location: Brazil

suction system to hold the blank

Post: # 48880Unread post juba bc
Sun Jan 07, 2018 10:03 am

 
Hello friends, someone here would know how to make an alternative suction system, adapted in the plate of a turntable to hold and leave the blank flat at the time of cutting?

User avatar
Prestofan
Posts: 65
Joined: Tue Oct 10, 2006 11:16 pm
Location: Port Tobacco, MD
Contact:

Re: suction system to hold the blank

Post: # 48885Unread post Prestofan
Sun Jan 07, 2018 9:35 pm

If your lathe gets the source for advancing the lines per inch by means of setting on the spindle of the turntable, it would be quite impossible. If yours is clear of the spindle, that is, it gets the power to advance the head by another means, there is another way. PM me for e-mail address and I could give you some hints.

Prestofan

User avatar
juba bc
Posts: 66
Joined: Thu Nov 06, 2014 8:58 am
Location: Brazil

Re: suction system to hold the blank

Post: # 48892Unread post juba bc
Mon Jan 08, 2018 8:37 am

thank you ... due to my bad english, I'll go over here the image of my frankenstein
http://uploaddeimagens.com.br/images/001/241/785/full/20180108_111221.jpg?1515418136

Post Reply