suction system to hold the blank
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
suction system to hold the blank
Hello friends, someone here would know how to make an alternative suction system, adapted in the plate of a turntable to hold and leave the blank flat at the time of cutting?
Re: suction system to hold the blank
If your lathe gets the source for advancing the lines per inch by means of setting on the spindle of the turntable, it would be quite impossible. If yours is clear of the spindle, that is, it gets the power to advance the head by another means, there is another way. PM me for e-mail address and I could give you some hints.
Prestofan
Prestofan
Re: suction system to hold the blank
thank you ... due to my bad english, I'll go over here the image of my frankenstein
http://uploaddeimagens.com.br/images/001/241/785/full/20180108_111221.jpg?1515418136
http://uploaddeimagens.com.br/images/001/241/785/full/20180108_111221.jpg?1515418136