Need for help and for information

Anything goes! Inventors! Artists! Cutting edge solutions to old problems. But also non-commercial usage of record cutting. Cost- effective, cost-ineffective, nutso, brilliant, terribly fabulous and sometimes fabulously terrible ideas.

Moderators: piaptk, tragwag, Steve E., Aussie0zborn

Post Reply
User avatar
CedLathe
Posts: 4
Joined: Tue Feb 07, 2017 7:23 am

Need for help and for information

Post: # 49223Unread post CedLathe
Sun Feb 04, 2018 12:17 pm

Hello everyone.
Being French, I go through a translator, forgive me if there are errors ...

Passionate about vinyl, I bought on Ebay an engraver dating from the 50s ... 60 .. I think ...

It is in 45t and 33t, and works in 110v.

By cons I'm no information about the brand ... what it's worth ... and my first test (on CDR) are not famous ... I think even the tip of engraving is not suitable. ..

Can you help me to know a little more ?? A big thank you in advance for your valuable help

Cedric
IMG-0363.JPG
You do not have the required permissions to view the files attached to this post.
Last edited by CedLathe on Sun Feb 04, 2018 12:21 pm, edited 1 time in total.

User avatar
CedLathe
Posts: 4
Joined: Tue Feb 07, 2017 7:23 am

Re: Need for help and for information

Post: # 49224Unread post CedLathe
Sun Feb 04, 2018 12:19 pm

IMG-0364.JPG
You do not have the required permissions to view the files attached to this post.

User avatar
CedLathe
Posts: 4
Joined: Tue Feb 07, 2017 7:23 am

Re: Need for help and for information

Post: # 49225Unread post CedLathe
Sun Feb 04, 2018 12:20 pm

IMG-0366.JPG
You do not have the required permissions to view the files attached to this post.

Post Reply