Audax RH5 stylus?
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
Audax RH5 stylus?
Is there anywhere to get a new stylus for an Audax RH5?
You do not have the required permissions to view the files attached to this post.
Re: Audax RH5 stylus?
Perhaps a few dimensions would be useful ie overall length diameter of shank & what material do you intend to cut (or emboss)
Re: Audax RH5 stylus?
I’d like to cut lacquers.
I believe it’s SHORT SHANK 5/8" OVER-ALL STYLUS LENGHT.
I believe it’s SHORT SHANK 5/8" OVER-ALL STYLUS LENGHT.
Re: Audax RH5 stylus?
Yes it a short shank , you may ask Mike Dixon. He'll probably have
Epos Laboratory Phono Cartridge Retip & Lathe Cuts
http:\\www.eposlab.gr
info@eposlab.gr
IG EposLab (https://www.instagram.com/eposlab/?hl=en)
http:\\www.eposlab.gr
info@eposlab.gr
IG EposLab (https://www.instagram.com/eposlab/?hl=en)
Re: Audax RH5 stylus?
are you looking to cut or emboss? I haves some short sapphire if you are cutting lacquers. If your embossing on polycarbonate, talk to mike about his cones .They have give me the best results. But before you give up on your styles, try using it to emboss on polycarb sheet . When they start adding squeak or floor noise, I turn them 190 degrees for embossing. Lean 3 to 5 degrees forward, put 35grams of weight as a starting point .Then through a microscope, adjust to 3mil groove. Some claim to get as clean a sound as the cones, or better. any way on the off chance you found some lacquers and wanted to cut them , i have some sapphire .dm me
Re: Audax RH5 stylus?
meant 180 degrees sorry