The Secret Society of Lathe Trolls

Hello Mossboss.

Thank you very much for all these clarifications and information.

Cordially.

Hello MossBoss and thank you for your suggestions.

OK it's noted.

I made this weekend a tank to test the electrochemical cleaning.
You indicate use this approach for several seconds.
What amperage advise you to apply it? 10A?

Thank you in advance for your help.

Hello and thank you for your answer.
I heard it was better to spend a very fine polishing on the father's surface to break up the groove for an easier release of the vinyl during pressing .
The Ouator is a cotton soaked in liquid polish .

Cordially.

Hello.

Let me back up my post to see if people on this forum have sugestions to offer me ?

Cordially.

Hello everyone.

I have a question regarding the reading of mothers.
Who saits cellue what is best for this kind of listening and any adjustment made on the tone arm?

Thank you in advance for your advice.

Best Regards.

No idea?

Hello dear forum members. I have a question about how to clean the "mother" apès polishing its surface with cotton Ouator. This polishing leaves dark fat on the face. Who knows the cleaning process to make the "mother" completely clean? Which product must use it for cleaning and how? Should you use ...

Hello.

I have no information if lacqers are very fresh ...
I tried to shave outside all ways : full, partial and without shaving .
The result is always the same ....

Cordially.

Hello to all forum members. I have a question about lacqers MDC. My plating bath we worked until now with Apollo lacqers or Transco. We started to do some testing with lacqers MDC, but we encountered a problem. After electroplating, when the separation of the stamper lacqer, lacqer layer detaches co...

Good price !!!!

Hello Celine.

Thank you for your message.
I just write you privately message.

Awaiting you.

Kind regards.

Hello to everyone in the forum.

I am looking for a machine to center the stampers and a cutting machine stampers.
A person would have this, or plans to achieve?

Thank you in advance for your porpositions.

No proposals ?

No proposals ?

Hello to all friends of the forum. In order to improve my work Electroplating (https://www.facebook.com/galvanoforming), I am looking for a pre - plating bath. I consider all serious proposals for a used bath or if a person has any plans or experience to perform the same home. Thank you in advance f...

Hello to all friends of the forum. In order to improve my work Electroplating (https://www.facebook.com/galvanoforming), I am looking for a hot pre - plating . I consider all serious proposals for a used bath or if a person has any plans or experience to perform the same home. Thank you in advance f...

?

Tnk's Kalia !

Hello Andreas. There a few years ago, I visited a small factory in Russia and there was one of these baths was going from left to right. Connected to the bath, there was one (even bigger than your picture) really big power :shock: ..... So I guess it was for the rapid electroplating. I hope avoire c...

Hello Péter.

Thank you for your message and your encouragement !