The Secret Society of Lathe Trolls

Yeah some of us aren't in the US... Aussie here mate!

I'll help you from Australia. We answer all emails with pride and good service. PM Me!

I bought a Victorinox knife sharpener and it works a treat! google it

thanks!

Send back to Souri. He will fix it for you.

Can't seem to find that?

Hey folks..

What's the best vacuum pump to get in Australia or close by? I have a VR...

I am currently using a house hold vacuum which has done fine, it is in another room, but want something quieter now...

Thanks!

Hey folks..

What pick up (monitoring) needles/cartridges do you use?

I am using a Shure White label. Can no longer get the authentic Shure tips, so will need to change. I always liked these pick up needles.

Any recommendations will be greatly appreciated....

Thanks for this!

When you say 'dynamic head' will this work with the default one from Souri?

Mine was posted to Australia. All good. If I could do it all again I would ditch most of the Souri equipment as it's not good.

Just the cutterhead and main mechanical parts. Leave the audio stuff and buy your own locally... and better quality!

Not sure about deposit. It’s a large machine but you should just buy the main parts, without his amp, mixer, and other hardware as you’ll replace them for better cuts.

So yes you should be able to take that in a padded suitcase. But take some bubble wrap too

How much are these? Fit on VR?

Any updates on this?

Please PM me info and costs thanks!

HannesFTL wrote: ↑

Wed May 01, 2024 4:03 am

The input is in normal operation (motor speed control via dial on front) when it is shorted. When short pin is removed the motor will run at full speed.

Thanks but I am not sure what that means?

Thank so much!

I have seen the one for 3500 euro... Prefer to make my own
system I think..

paulo32 wrote: ↑

Sat Jan 15, 2022 4:23 am

Also I finally had some time to finish the website, everything is up and running, you may check additional informations on the GM1 System here:
https://sawasoundengineering.com/product/gm1/

Please can you PM me with costs to Australia?

I tried a PM, did you receive it? Please PM back as I am interested in parts!

Hello! I am contemplating automising the groove speed controller, my thinking is to run another track about a second ahead which analyses the amplitude, then sends signal back to the groove speed controller.. Is there anything in existence for VR? Has anyone had success with this, and would like to ...