The Secret Society of Lathe Trolls

https://filebin.net/eom3oyz0wco7326k/IMG_4377.JPG?t=xyxir3t1
again picture of MT32, hope you can see it.

Thank you helloheaten !
Here there is a picture of it:
https://filebin.net/eom3oyz0wco7326k/IMG_4377.JPG?t=odza5yaz

Complete Neumann MT32 console whit telefunken m10 preview tape , 4x v87 , one v86, 4x v72 preamps , one u73b compressor . open to offers
its located in Italy .
Giordano

just seen this yesterday on ebay maybe someone here could be interested , i think quite difficult to see them on the market , i had a though about it.
http://www.ebay.com/itm/Neumann-Control-Console-SP-79-/292182200911?hash=item44076a924f:g:DioAAOSwstJZTCqp

Hi ,thanks for the answer.so i was thinking right. I'm setting up a room with neumann vms 62 special, vg66 amps , sx74, whit modern pitch computer. don't know were yet , the plan was berlin but we have lot of things to consider so it's not sure. by the way i have a mtc-2 console now , i found it sec...

hi,is it a right thought that the HI Freq Limiter like the Maselec MDS it's needed only for the modultion channel because pitch control computer use only low to mid frequencies to space the grooves ? for control console there are :Dangerous Master,manley Backbone,Crookwood ,Maselec mtcx1 and mtc2. i...

didn't though that eventuality yes for sure cutting lathe are very valuable machines. just want to take care of my new old lady so if you want's to give me some advice for the moving work please pm to me privately we can continue this trade whit loudspeakers anyone had never listen or got info & spe...

i have to move a neumann vms62special lathe with sx74 cutterhead. please info about the work for what i think i have understand, i have to disassemble : - the cutting head - the carriage - the disk plate (after draining oil ) - the lathe from zt base (after motor been detached) rigth? what else? i'm...

thinking it's an 1 Aprils hoax.
no e mail address found to answer this post.
interested to the vms 70
but from the website seems their are serious people!
i'm new in the business just thinking to set a cutting studio ,
any help suggestion welcome .