Where does the oil go for the presto 6n motor

[Jccc]

i was wondering if there is way to oil up the presto 6n motor that powers the turntable.
Just recently for some reason when im cutting on 33 1/3 the turntable starts to spin super slow.

Also sometimes when i turn the motor on to 33 1/3 the motor does not start. It works perfectly some times on 78.

Could it be that i new rubber rollers for it?

[cymbalism]

There are two pots, one at the top on the right side of the 78 puck, the other is on the bottom and has a silver or gold pipe running to it

[piaptk]

Take the platter off and see if the capstan starts spinning when you engage the 33. You might just need to adjust the screw back a litle so that the idler gets pushed in to the capstan a little harder. Also make sure your switch is still aligned right... Mine got off it's axis a little and I hve to use a loop of wire to start it...

[cymbalism]

Also check the connections on your power switch. My second 6n wouldn't spin on 78, I replaced the switch now all is well

[Jccc]

Thank you guys for help. I got it oiled up and running.

The power switch was loose so i tightened it up and its all good now.

[cymbalism]

No prob