Where does the oil go for the presto 6n motor
i was wondering if there is way to oil up the presto 6n motor that powers the turntable.
Just recently for some reason when im cutting on 33 1/3 the turntable starts to spin super slow.
Also sometimes when i turn the motor on to 33 1/3 the motor does not start. It works perfectly some times on 78.
Could it be that i new rubber rollers for it?
Just recently for some reason when im cutting on 33 1/3 the turntable starts to spin super slow.
Also sometimes when i turn the motor on to 33 1/3 the motor does not start. It works perfectly some times on 78.
Could it be that i new rubber rollers for it?
Take the platter off and see if the capstan starts spinning when you engage the 33. You might just need to adjust the screw back a litle so that the idler gets pushed in to the capstan a little harder. Also make sure your switch is still aligned right... Mine got off it's axis a little and I hve to use a loop of wire to start it...
I Buy/Sell/Restore Vintage Machines/Parts and Provide Phone/In Person Tech Support
www.MichaelDixonVinylArt.com
www.LatheCutCamp.com
www.RecordLatheParts.com
www.MobileVinylRecorders.com
www.LatheCuts.com
www.MichaelDixonVinylArt.com
www.LatheCutCamp.com
www.RecordLatheParts.com
www.MobileVinylRecorders.com
www.LatheCuts.com