no sound from groove.
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
no sound from groove.
I recently read a posting regarding a troll cutting but getting no sound
on playback
I am using new saphire and I am getting sound at the cutter head
and can feel vibration at the stylus but only background noise on
playback I have tried adjusting depth of cut and stylus angle, probably something obvious - sure I read someone on this forum with similar problem just cant locate it
any help appreciated
emidisc
on playback
I am using new saphire and I am getting sound at the cutter head
and can feel vibration at the stylus but only background noise on
playback I have tried adjusting depth of cut and stylus angle, probably something obvious - sure I read someone on this forum with similar problem just cant locate it
any help appreciated
emidisc
hmmm... I don't know this cutter. I had a similar thing with Audax h4. When it came I got sound from it and thought everything is ok. But when cutting I got very low sound.
I took apart and saw that rubbers used as dampers where worn out or got exhausted through time. Then I changes to what I had on hand - and that was 1mm silicon technical rubber. Worked better after all.
Maybe you have the same problem?
I took apart and saw that rubbers used as dampers where worn out or got exhausted through time. Then I changes to what I had on hand - and that was 1mm silicon technical rubber. Worked better after all.
Maybe you have the same problem?