Hello there,
Hope everyone is doing great.
I have a little anomaly going on with my T560....
When I cut unmodulated groove it's sounds very cool and surface noise is very acceptable.... but sometimes (not on every disc) there's like click and noises only during the really soft fade ins....but not on unmodulated groove...
When I increase stylus heating sometimes it helps ...sometimes it doesn't
Any ideas?
Cheers
Ben
Problem with clicks and noise
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
Re: Problem with clicks and noise
interesting, try to look closely at the chip pickup, and also the blank condition when cutting.
I've found those two factors to contribute very highly to the quality of the cut, with all other factors being the same.
I've found those two factors to contribute very highly to the quality of the cut, with all other factors being the same.
making lathe cuts on a Presto 6N, HIFI stereo cuts on vinylrecorder
at Audio Geography Studios, Providence, RI USA
http://www.audiogeography.com
at Audio Geography Studios, Providence, RI USA
http://www.audiogeography.com