I'm looking for experienced polycarbonate embossing (cutters are also fine, although I read diamond + polycarbonate is rare) engineers for a 30-run project.
The records are not conventionally made and are quite thicker (~6mm) than the average 12 inch record (~1.5mm).
These prototype records are made for an art exhibition.
I'm looking for experienced engineers who would be interested in approaching an experimental project with the following details:
Location: Preferably but not limited to East Asia
Genre: ambient/techno
Tracks: ~ 30 minutes
Run: 30, 12-inch polycarbonate records
Method: Sapphire emboss/Diamond lathe/your recommendation
Interested in all leads, recommendations, and referrals!
- plasticmastic
- Posts: 5
- Joined: Sat Aug 21, 2021 4:30 am
Re: You released a record you are most proud of. Where would you go to cut/emboss it? Who is your cutter?
I may be able to help you. Sounds up my alley. Email details to LatheCuts-AAAAT-yahooooo-Dawt-Cawm
I Buy/Sell/Restore Vintage Machines/Parts and Provide Phone/In Person Tech Support
www.MichaelDixonVinylArt.com
www.LatheCutCamp.com
www.RecordLatheParts.com
www.MobileVinylRecorders.com
www.LatheCuts.com
www.MichaelDixonVinylArt.com
www.LatheCutCamp.com
www.RecordLatheParts.com
www.MobileVinylRecorders.com
www.LatheCuts.com