Just picked up a piercing cylinder
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
- filtersweeper
- Posts: 38
- Joined: Fri Feb 05, 2010 6:41 pm
- Location: Canada
- Contact:
Just picked up a piercing cylinder
One of these three models:
PR824-800-OFF-.34-UR8-24Z3
PS824-538-FBL-.50-UR-16Z3,
PS824-800-CFF-.344-UR8-16Z3
8 inch stroke, with 1/2" power stroke. It was only 200$ so I figured we'd give it a go.
Here's the PDF:
ftp://clftp.cntrline.com/Product%20Information%20%26%20Support%20Materials/Piercing%20Cylinders%20%26%20Presses/Piercing%20Cylinders/OHMA%20Piercing%20Cylinder%20Product%20Guide.pdf
More updates as they come
- filtersweeper
- Posts: 38
- Joined: Fri Feb 05, 2010 6:41 pm
- Location: Canada
- Contact:
the biggest on in this pdf (8") can do 50tons with 70 psi?
I don´t understand that principal...
I think:
http://www.youtube.com/watch?v=PNnqjbojqjE
I think, this one is good for a label puncher...
I don´t understand that principal...
I think:
http://www.youtube.com/watch?v=PNnqjbojqjE
I think, this one is good for a label puncher...