I have recently discovered the wonderful world of lathe cutting.
I wish to design full diy cutting lathe . I have a few newbie questions:
1. What material is the base spring for the torsion bar? which thickness usually is it?
2. What is the importance of the cones? which part should they be connect to (large or small diameter of the diaphragm). Which material is recommended? I assume they affect the sound.
3. Can I use arduino for transferring sound to the drivers? what is recommended?
4.Can you recommend nice basic driver?
5. Can you recommend a decent stylus? (from where to buy)
6.Will stepper motors will be ok for moving the head or they will make a lot of noise while recording?
Any other tips will be very welcome.
Thanks all !
