The book is long out of print, and used copies are very difficult to find and pricey:
But check local libraries. I did and found a number of copies in Calif. university libraries.
-
grooveguy
- Posts: 430
- Joined: Thu Jun 22, 2006 5:49 pm
- Location: Brea, California (a few miles from Disneyland)
- Contact:
Re: A simple and inexpensive stereo cutter YOU can build!
Hi, symatic!
The book is long out of print, and used copies are very difficult to find and pricey:
But check local libraries. I did and found a number of copies in Calif. university libraries.
The book is long out of print, and used copies are very difficult to find and pricey:
But check local libraries. I did and found a number of copies in Calif. university libraries.
-
grooveguy
- Posts: 430
- Joined: Thu Jun 22, 2006 5:49 pm
- Location: Brea, California (a few miles from Disneyland)
- Contact:
Re: A simple and inexpensive stereo cutter YOU can build!
Well, that image insert doesn't seem to work; here's a direct link: https://www.dropbox.com/s/liziad8cur9yb77/Snap13.jpg?dl=0
Re: A simple and inexpensive stereo cutter YOU can build!
nice one for the link grooveguy!
Re: A simple and inexpensive stereo cutter YOU can build!
Just thought I would post a link in here for anyone who is interested. I have built a stereo cutting head based on this design. If anyone is interested you can check it out here
https://www.lathetrolls.com/viewtopic.php?f=15&t=9398&p=59923#p59923
Thanks again to Grooveguy for posting this design to begin with. I don't think I would have had the confidence to attempt this if it hadn't been for this.
https://www.lathetrolls.com/viewtopic.php?f=15&t=9398&p=59923#p59923
Thanks again to Grooveguy for posting this design to begin with. I don't think I would have had the confidence to attempt this if it hadn't been for this.