After a long old while, i now finally have my lathe and cutting amp up and running (REF:here) but the lathe needs a new drive belt and I'm not sure on what material would be the best for a replacement, or does it not matter?
So far I'm looking at getting either
Nylon Re-inforced Flat Rubber Drive Belts - https://simplybearings.co.uk/shop/Belts-Flat-Drive-Belts/c4601_8093/index.html OR Polyurethane - https://www.motionco.co.uk/index.php?route=product/round_belt
Although i just found this site: https://store.lathes.co.uk/belts which has many different types.
Can anyone advise on which is the best one to get?
Thank you.
HMV 2300H Drive belt advice
Moderators: piaptk, tragwag, Steve E., Aussie0zborn