Hello all,
I recently had a few sheets of "0.06 (1.5mm) polycarb cut and figured I'd have a bunch of 3.15" discs cut from the scrap just in case my machine could emboss onto them, but alas, no such luck. Anyone have any use for them? I'll probably hang onto some just for fun or craft stuff, but if your machine can emboss on them and you have any interest, lmk. Happy to send them out for free, shipping covered would be appreciated. I'd much rather they go to someone who can use them than sit in my closet for a few years before throwing them out.
- Joe
displacedsnail.com
Any use for 3.15" polycarb discs?
Moderators: piaptk, tragwag, Steve E., Aussie0zborn
- displacedsnail
- Posts: 23
- Joined: Sat Aug 12, 2023 8:34 am
- Location: Philadelphia, PA
- Contact:
Any use for 3.15" polycarb discs?
You do not have the required permissions to view the files attached to this post.