Silvertone cutter head

This is where record cutters raise questions about cutting, and trade wisdom and experiment results. We love Scully, Neumann, Presto, & Rek-O-Kut lathes and Wilcox-Gay Recordios (among others). We are excited by the various modern pro and semi-pro systems, too, in production and development. We use strange, extinct disc-based dictation machines. And other stuff, too.

Moderators: piaptk, tragwag, Steve E., Aussie0zborn

Post Reply
User avatar
Spectrum1
Posts: 3
Joined: Tue Nov 07, 2023 3:06 pm

Silvertone cutter head

Post: # 63779Unread post Spectrum1
Fri Dec 01, 2023 7:36 am

Hi pleasant day to all just as we embark upon such festive season of Xmas

I must first let you know I have got very little knowledge about lathe cutting and any advice will be humbly accepted.

I have a silvertone 3751 1941 model The amplifier works. But would not get the levels for today standard so I am using a separate amp, I am just using the platter but the head was a crystal head and I would like to replace it with a magnetic head ? Any ideas? Which other head could work on this unit as it has limited space due the configuration at the time.

Any help is appreciated


Kind Regards
Pablo
Top

Click Here!

User avatar
Spectrum1
Posts: 3
Joined: Tue Nov 07, 2023 3:06 pm

Re: Tube amplifier

Post: # 65726Unread post Spectrum1
Sun Sep 15, 2024 11:40 am

Hi good day can anyone help with this question I have a tube amp and I would like to use the plat voltage from the EL34 to drive the crystal head. But the problem is that it’s a push pull … Not a single ended. Transformer …. Can someone say if it is possible to. Use a push pull Tho do the job Any help is Appreciated kind regards.
Pablo
Top
Post Reply

Click Here!