I managed to make 5 in about an hour...
I still require the correct epoxy resign and varnish sealant to do them properly and then wire them up, but so far so good...
I also plan to get the bobbin bits die cut "instead of scissor and stanley knife"
![Smile :)](./images/smilies/icon_smile.gif)
Check out these...
![Image](https://fbcdn-sphotos-d-a.akamaihd.net/hphotos-ak-ash3/944643_640587395959552_230134717_n.jpg)
![Image](https://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-prn2/1157526_640587659292859_1416113256_n.jpg)
![Image](https://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-prn1/996576_640585092626449_728974769_n.jpg)
![Image](https://fbcdn-sphotos-b-a.akamaihd.net/hphotos-ak-ash3/933961_640586442626314_1718244182_n.jpg)
![Image](https://fbcdn-sphotos-e-a.akamaihd.net/hphotos-ak-frc3/1173718_640586942626264_747562341_n.jpg)
![Image](https://fbcdn-sphotos-a-a.akamaihd.net/hphotos-ak-prn2/1173718_640586949292930_1049220038_n.jpg)