any proposition will be considered.
-
talbanjean
- Posts: 30
- Joined: Fri Jul 08, 2016 10:00 am
Looking desperately for SP-10 Technics friendly 14 inches platter
WTB 14" platter for SP-10 or DFX file for steel company accomodation.
any proposition will be considered.
any proposition will be considered.
-
petermontg
- Posts: 611
- Joined: Sat Jun 26, 2010 7:51 am
- Location: Ireland.
Re: Looking desperately for SP-10 Technics friendly 14 inches platter
If you can find the dimensions/details, I'll stick together a .DFX for you.
Best
Peter
Best
Peter
Peter Montgomery
+353(0)894926271
peter(at)petermontgomerymastering.com
Stereo cutter head wanted. Send email or smoke signals.
+353(0)894926271
peter(at)petermontgomerymastering.com
Stereo cutter head wanted. Send email or smoke signals.
Re: Looking desperately for SP-10 Technics friendly 14 inches platter
Admittedly, mine isn't quite a 14" plate, but it does fit my SP-10 mk II very nicely!
In case you're interested, just measured it and its dimensions are (all in mm):
323 total diameter
8 underside rim width
3 underside rim recess
307 inner diameter
7 thick
3x levelling grub screws, 20 in from plate edges at equidistant points around the disc
grub screws are of hex type and have conical ends
Hope this helps!
In case you're interested, just measured it and its dimensions are (all in mm):
323 total diameter
8 underside rim width
3 underside rim recess
307 inner diameter
7 thick
3x levelling grub screws, 20 in from plate edges at equidistant points around the disc
grub screws are of hex type and have conical ends
Hope this helps!
-
petermontg
- Posts: 611
- Joined: Sat Jun 26, 2010 7:51 am
- Location: Ireland.
Re: Looking desperately for SP-10 Technics friendly 14 inches platter
Can you take a photo of the underside of platter.
If it's possible.
Best
Peter
If it's possible.
Best
Peter
Peter Montgomery
+353(0)894926271
peter(at)petermontgomerymastering.com
Stereo cutter head wanted. Send email or smoke signals.
+353(0)894926271
peter(at)petermontgomerymastering.com
Stereo cutter head wanted. Send email or smoke signals.
Re: Looking desperately for SP-10 Technics friendly 14 inches platter
Hey Peter,
I can do better than that!
PM sent.
I can do better than that!
PM sent.
-
talbanjean
- Posts: 30
- Joined: Fri Jul 08, 2016 10:00 am
Re: Looking desperately for SP-10 Technics friendly 14 inches platter
hi!
did u finally get one?
stilll looking for this damn platter for my T 560...
regards
did u finally get one?
stilll looking for this damn platter for my T 560...
regards