Need info on wiring up the cutterhead atom A 101

[Akimbrough0112]

Hi I purchased a Atom A 101 on eBay. Kind of a basket case, anyway the wiring is missing off of the cutterhead and it is not hooked up inside the unit so I was wondering if anybody would be able to tell me how to put the wiring back together. Also anybody know of any parts machines for sale thanks Alan

[Fela Borbone]

I I recall correctly, it has 3 wires, two for the cutterhead itself an a third that go to a terminal for stylus heating, if used. Stylii for this machine ("Presto"type) have only one wire for heating, and the shank connects to ground. But you dont really need heating, anyway.

[Fela Borbone]

I just see you have no wiring al all... well, it should be connected at the output of the amplifier, as it were a speaker

[Fela Borbone]

I mean, the cutter head

[mrd]

I've got a couple of photos of when I last opened mine which might help to get started. I can get round to tracing properly in due course but the first two if you take the head off as pictured on the left (red/white) are the audio signal to the head and connect to some raised spade connectors as pictured internally. The other two are for the heater wire I believe.

[mrd]

[discosdecorte]

Hi I purchased a Atom A 101 on eBay. Kind of a basket case, anyway the wiring is missing off of the cutterhead and it is not hooked up inside the unit so I was wondering if anybody would be able to tell me how to put the wiring back together. Also anybody know of any parts machines for sale thanks Alan

Hi! I've just sent you a PM

Best regards,
Fer